Hyperliquid grid bot
A grid bot on Hyperliquid, in your own account.
Buy below the price, sell above it, and earn on every move inside the range.
More
Pick the range on the chart, see the profit per grid after every fee, backtest it, and start. No subscription.
What you get
| What you used | On Rivemont | Status |
|---|---|---|
| Long, short or neutral grids | One choice in the Bot Terminal. | Same on Rivemont |
| Range on the chart | Click both ends of the range, or drag the lines. | Same on Rivemont |
| Profit per grid after fees | Shown before you start, with a warning when a grid is too tight to beat the fees. | Same on Rivemont |
| Backtest | How the same grid did on past prices. | Same on Rivemont |
| Stop outside the range | Close all and stop if the price leaves it. | Same on Rivemont |
| Spot grids | Not offered: perps only. | Not available |
Why run it on Rivemont
Start a grid in 5 minutes
- Connect your walletOpen rivemont.xyz in your wallet app's browser (Rabby, MetaMask) or use WalletConnect.
- Approve accessA few signatures in your wallet: a key for the exchange and, where it applies, the 0.1% fee cap.
- Fill in your old settingsUse the form on this page.
- Check them in the Bot TerminalIt opens with the settings filled in, the grid lines or orders drawn on the chart, and the profit per grid after fees.
- StartConfirm and the bot runs in your own exchange account.
Signing in to Rivemont is one free signature. Connecting an exchange takes a few more; how many, and any small network cost, depend on the exchange: see each exchange's connect guide.
Grid settings from other apps → Rivemont
Grid bot (6)
| Your old setting | Rivemont field | How to move it |
|---|---|---|
| Direction (long, short or neutral grid) | Direction | Same choice. |
| Lower / upper price | Low / High | Same prices. |
| Number of grid levels or lines | Grids | Levels minus one: Rivemont counts the gaps between lines (10 lines = 9 grids). |
| Amount per grid order | Amount (USD) | Order size × grids. The form does this for you. |
| Leverage | Leverage | Same, up to the exchange's maximum for the coin. |
| Stop outside the range | If the price leaves the range, close all and stop | Rivemont stops at the range edge itself. |
Fill in your old bot, open it in the Bot Terminal
Type the numbers from your bot's settings screen.
Questions
How many grids should I use?
Enough that each grid's gap is well above the fees. The Bot Terminal shows the profit per grid after fees and warns you when a grid would lose on every round trip.
What happens if the price leaves the range?
With 'close all and stop' on, the bot closes and stops. With it off, the grid waits for the price to come back.
Does Rivemont hold my money?
No. It stays in your own Hyperliquid account; the key cannot withdraw.
What does it cost?
No subscription. From 0.1% per fill on the bot's trades, lower with your 30-day volume, plus Hyperliquid's own fees.
Draw your first grid
Open the Bot Terminal, pick the range on the chart, and read the numbers before you start.
More guides
Rivemont is an independent app and is not affiliated with the apps named on this page. Names are used only to describe compatibility. Trading perpetual futures carries risk, including the loss of all the money in a connected account. Terms and risks.